Electronic Theatre Controls Source Four Revolution Manual de usuario

Copyright © 2008 Electronic Theatre Controls, Inc.All Rights reserved.Product information and specifications subject to change.Part Number: 7060M1210-

8 Source Four CE User ManualEnglishShaping the beamThe beam can be shaped using the shutters (see Figure 8), a gobo, an optional drop-in iris, or by r

9EnglishStep 3: Insert the iris or motorized gobo device. For an iris, install the flat side toward the shutters and make sure the iris handle extends

10 Source Four CE User ManualEnglishSetting the angle within the yokeStep 1: Loosen the yoke locking knobs (see Figure 11). Do not remove them.Step 2:

11EnglishStep 1: Remove the beam focus knob at the bottom of the barrel (see Figure 1). Remove the lens tube from the barrel.Step 2: Use a Phillips sc

12 Source Four CE User ManualEnglishPortable appliance test (PAT) guidelinesThe Portable Appliance Test is a set of tests that must be administered to

13English

Corporate Headquarters  3031 Pleasant View Road, P.O. Box 620979, Middleton, Wisconsin 53562-0979 USA  Tel +608 831 4116  Fax +608 836 1736London,

iTable of ContentsETC®, Emphasis®, Expression®, Insight™, Imagine™, Focus™, Express™, Unison®, Obsession® II, ETCNet2™, EDMX™, Source Four®, Revolutio

1EnglishDeclaration of conformityWe, Electronic Theatre Controls, Europe Ltd. declare under sole responsibility that the product:Product name: Source

2 Source Four CE User ManualEnglishSource Four CE guidelinesThe Source Four CE is intended for professional use only. Read the entire User Guide befor

3EnglishBasic luminaireWARNING:Please note the following safety warnings before use:Do not mount the luminaire on or near combustible surfaces.Do not

4 Source Four CE User ManualEnglishLuminaire informationWiring and power informationA plug of at least 2.5 amp (220/240V) rating should be attached to

5EnglishColour frame holderThe colour frame holder is equipped with a spring-loaded retaining clip that prevents colour frames and accessories from fa

6 Source Four CE User ManualEnglishReplacing the HPL lampA lamp must be installed before you use the luminaire.Step 1: Disconnect power to the Source

7EnglishCentering lamp and adjusting the fieldThe two concentric knobs located on the lamp housing allow you to align the lamp and adjust its field. S