ETC Release Note:
Eos Family Software v2.1.0
Eos Family v2.1.0 Release Note Page 8 of 13 Electronic Theatre Controls, Inc.
• One combined network and one limited traffic for wireless devices
To update GCE:
You will need to have v2.0.0 installed on your console first. See “Software Installation” on page 5.
Step 1: Download the software from the ETC website (www.etcconnect.com
- click
“Downloads” at the top of the page).
Step 2: Unzip the file.
Step 3: Transfer the unzipped file to a USB memory device.
Step 4: Insert the USB device containing the software into an available USB port on the
console.
Step 5: Open the Eos Configuration Utility (ECU - Also known as the Eos Shell) either by
exiting the Eos Family software (Browser>Exit) or by starting up the console and
clicking on the {Launching in...} button. The ECU screen will open.
Step 6: Click on the {Settings} button. The settings window will open.
Step 7: Click on the {General} button inside of the settings window. The general settings will
appear in the window.
Step 8: Scroll down in the window until the {Software Update...} button is visible. Click this
button.
• This scans the root directory of all available drives (USB drives) for valid
installers.
Step 9: When the “Update Software” dialog pops up, click on the GCE Net3Services.exe file
(v3.1 or higher), then click {Install}.
• The software will copy to the hard drive before launching a standard
Installshield application to direct you through the install.
Step 10: Click {Next} to start the installation process.
Step 11: Accept the terms of the license agreement and click {Next}.
Step 12: Select Console Mode and click on {Next}. This starts all services automatically
upon booting the console. This is the factory default state for new consoles.
Step 13: Select whether Net3 Services should run in Server or Client mode.
• Server Mode. When running as a Server, the console will act as a source for DHCP
addresses, SNTP (time) messages and as a TFTP source for software downloads
to compatible devices. In general, there should only be one Net3 Services Server
on a network at a time. This is the factory default state for new consoles.
• Client Mode. When running in Client mode, the console will receive SNTP (time)
messages. The TFTP service always acts as a server, even in client mode.
Configuring the console to receive a dynamically assigned IP address via DHCP is a
separate choice and must be configured via the ECU (Settings>Network) on a given
console.
Step 14: Depending on the choice you made, you may have a confirmation dialog to
acknowledge, then click {Install} to start the installation process. When the
installation is complete, the installer will put you back into the Eos Configuration
Utility. A reboot of the desk is required.
To enable the second network port on Gio:
To configure the second Ethernet port on a Gio console to match factory defaults, follow the
instructions below. Otherwise, you may configure the second port to match your system
Note:
The two Ethernet ports must be configured to separate networks (subnets).
For proper operation, the two ports must NOT be connected to the same physical
network.
(380 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales