Electronic Theatre Controls PARADIGM Manual de instalación descargar pdf (Pagina 20)

16 Unison

ERn Wall Mount Enclosure Installation Manual

Connect Line Power Wiring

ERn enclosures are available in 100-120, 230 CE, and 240 VAC single phase

configurations. The ERn enclosure requires a single phase, 20 amp (maximum) at 120 VAC

input feed or a 15 amp (maximum) at 230 and 240 VAC. The two-wire hot and neutral

terminates to the power input terminal block (top left) and a ground wire terminates to the

ground bar.

Step 1: Pull the line, neutral, and ground cables to the enclosure through the conduit

openings previously prepared.

Step 2: Insert the ground wire into a screw terminal on the ground terminal block and

secure.

Step 3: Insert the neutral wire into the neutral screw terminal on the power input terminal

block and secure.

Step 4: Insert the line (input feed) into the line screw terminal on the power input terminal

block and secure.

WARNING:

All rack terminations must be done with the power off. Racks installed

without an accessible power disconnect device cannot be serviced or

operated safely.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

Sin comentarios

Electronic Theatre Controls PARADIGM Manual de instalación Pagina 20