Electronic Theatre Controls Emphasis Lighting Control System Especificaciones descargar pdf (Pagina 115)

7 Basic Manual Control 101

Form Control

Form (a subcategory of Beam) collects the parameters that affect the quality of the beam, including

the iris, edge, frost, etc. ‘Shutter’ and ‘Image’ are the other two subcategories of Beam

When the [Form] encoder page button is selected, the LED will illuminate and the encoders

automatically populate with the “Form” parameters as specified in the show patch. If there are more

parameters in the show patch than will fit on the first page of the encoders, press the [Form] button

again to page through the remaining parameters in the category or press [Form] and a page

number to jump to a specific page.

The form parameters may include:

• Edge - controls the hard and soft qualities of a spot luminaire. While some fixtures may call

this parameter “focus”, it is always represented as “edge” in Ion, to avoid confusion with

“Focus” which refers to pan and tilt data. The edge encoder provides two buttons, [Hard] and

[Soft], which set the selected luminaire to its hardest (sharpest) edge or its softest edge. These

values are set to the system default value for the selected luminaire, but may be modified as

required on a per fixture basis.

• Iris, Zoom, Strobe and IMF- each parameter has in/out, narrow/wide, or fast/slow settings.

Iris and Zoom also have programmable limits, called in/out and narrow/wide respectively. The

strobe mode setting varies based on the fixture type.

Image Control

Image is the collection of parameters that affect the contents of the beam (gobo, prism, effects

wheel, etc.).

Shutter Control

Pressing the [Shutter] button displays shutter controls, if there are any fixtures with framing devices

patched. The encoders control either the “Frame in” parameter or the “Frame Angle” for all available

shutters. Use paging to access the other shutters.

• Frame in- determines how far in and out of the beam the blade travels.

• Angle - determines the angle that the blade sits in the beam.

Different fixtures control shutters in different ways. Ion provides you standardized use of all shutters

through patch.

Press the [Shutter] button again to access the additional shutter controls, available to the specific

channel.

Color Control

Depending upon the specific device, color can be established manually with the encoders using:

• CMY color mixing

• Hue and saturation color mixing

• RGB color-mixing

• Selection from a color wheel or scroller

You may also specify color by using the hue and saturation (HS) color picker.

It is also possible to set non-intensity parameter data with direct entry using the control keypad and

using the parameters on the CIA.

• [1] [At] [4] <0> {Cyan} [5] [5] [Enter]

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 337 338

Sin comentarios

Electronic Theatre Controls Emphasis Lighting Control System Especificaciones Pagina 115