Electronic Theatre Controls Emphasis Lighting Control System Especificaciones descargar pdf (Pagina 204)

190 Ion Operations Manual

Using [Copy To]

[Copy To] allows you to copy data from one channel to another, either within the current working

mode or to a different record target. [Copy To] works much like [Recall From], but in the opposite

direction, [Copy To] forces data to a channel from the selected channel, whereas [Recall From]

pulls it from a channel to the selected channel.

You may copy all parameter data for selected channels, or by using the IFCB category buttons or

parameter buttons, you may copy subsets of channel data. Entire cues, cue ranges and cue lists

can be copied to other locations.

When copying information at a channel level, discrete timing is not included unless specified. When

copying entire cue(s), all timing data is copied. When referenced data is copied, if the copy target

also has data in the reference that is being copied, the target will be placed in that reference (such

as, CP 1), at its stored values. If the copy target is not included in the reference, absolute data will

be copied to the target, and not the reference.

Below are some examples of copy commands from record targets. This command is very versatile

and the following list is far from exhaustive:

• [2] [Copy To] [Cue] [5] [Enter] - copies all information for channel 2 to cue 5. Any discrete

timing data is not copied.

• [2] [+] [Time] [Copy To] [Cue] [5] [Enter] - As above, but timing data is included.

• [2] [Time] [Copy To] [Cue] [5] [Enter] - Copies just the timing data for all parameters of

channel 2 to cue 5.

• [2] [-] [Focus] [8Copy To] [Cue] [5] [Enter] - Copies all parameter data for channel 2, other

than focus, to cue 5.

• [Group] [3] [Copy To] [Preset] [6] [Enter] - copies current information for group 3 to preset 6.

• [3] Copy to] [6] [Cue] [y] [Enter] - copies the data from channel 3 to channel 6 in cue 8.

• [3] [Copy to] [4] [thru] [9] [Enter] - copies the data from channel 3 to channels 4 thru 9.

• [3] [Copy to] [8] [Cue] [2] [/] [1] [Cue Only/Track] [Enter] - copies the data from channel 3

to channel 8 in cue 2/1 and takes exception to the track/cue only settings in regard to

subsequent cues in cue list 2.

• [Cue] [2] [/] [Copy to] [Cue] [7] [/] [Enter] - copies all of the contents of cue list 2 to cue list 7.

• [Cue] [1] [/] [1] [thru] [1] [0] [Copy To] [Cue] [5] [/] [5] <thru> [Enter] - copies cues 1 thru

10 from cue list 1 to cue list 5, starting with cue 5.

1 2 ... 199 200 201 202 203 204 205 206 207 208 209 ... 337 338

Sin comentarios

Electronic Theatre Controls Emphasis Lighting Control System Especificaciones Pagina 204