Electronic Theatre Controls Emphasis Lighting Control System Especificaciones descargar pdf (Pagina 36)

22 Ion Operations Manual

Setting Up the Hardware

Follow these steps to prepare your Ion for use.

Step 1: Place your console on a firm, level surface. Be sure to leave space for access to the

rear of the console. You will need to connect several items to the ports on the back.

Step 2: Connect any monitors to the proper ports on the back of the console. Your monitor

connection choices are:

• Single VGA monitor connected to the blue VGA connector.

• Single DVI monitor connected to the white DVI port (using the “Y” cable).

• Single VGA (blue VGA port) and single DVI (white DVI port with “Y” cable).

• Two DVI monitors connected to the DVI port using the “Y” cable.

Step 3: Connect the keyboard and mouse. You may use USB or PS2 devices. Attach to the

appropriate connector on the back of the console.

Step 4: If you will be connecting to an Eos/Ion network, connect the appropriate ethernet

(CAT 5 or better) cable to the ethernet port on the back of the console.

Step 5: If you plan on using the DMX ports on the back of Ion to control your lighting system,

attach the appropriate DMX connector and cable to the desired port. This port may

need to be configured before you can output data. For more information, see Local

DMX, page 275 in the ECU appendix.

Step 6: Attach the appropriate IEC power cable for your location to the IEC connector on the

back of the console, just above the power switch.

Your console hardware is now ready to be powered up.

Note:

Any monitor attached to the DVI “Y” cable must be a DVI monitor. DVI-VGA

adaptors will not work with the “Y” cable.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 337 338

Sin comentarios

Electronic Theatre Controls Emphasis Lighting Control System Especificaciones Pagina 36