Electronic Theatre Controls Emphasis Lighting Control System Manual de usuario descargar pdf (Pagina 118)

108 Emphasis Console v2.0.0 User Manual

Channel Faders (Express Two-Scene/Insight only)

On Express Two-Scene facepanels and on Insight facepanels you have the option of

setting channel levels using the channel faders. Express Two-Scene facepanels have

dedicated channel faders, and Insight facepanels share channel and submaster faders.

Channel levels set with the channel faders are not captured, but will remain active under

HTP operation until the channel fader is moved back to the zero position.

To operate an Express Two-Scene console using channel faders, please see Express

Facepanel Two-Scene Operation, page 302 .

Use channel faders on Insight facepanels:

Step 1: The facepanel defaults to Submaster faders (the [Sub Mode] LED is lit). Press

[Sub Mode] to turn off the LED and switch to channel mode.

Step 2: Slide the faders to the levels you require.

Groups

If you find yourself selecting the same groupings of channels over and over, or you always

want to set levels for certain channels proportionally relative to each other, you can record

those channels with levels to a group. A group is a simple way to select multiple channels

with minimal key presses. You can also use recorded cues and submasters as groups, see

Using Cues as Groups, page 116 and Using Submasters as Groups, page 124 for more

information.

Record a group:

Step 1: Select channels using the procedure described in Select Channels, Dimmers

and Fixtures, page 86.

Step 2: Set levels using the procedure described in Set Levels, page 89. Only channels

with levels are recorded into groups.

Step 3: Press [Record] [Group] [x] [Enter], where [x] is the group number.

Recall a group:

• Press [Group] [x] [Full], where [x] is the group number, to recall the group as it was

recorded.

• Press [Group] [x] [At] [y], where [x] is the group number and [y] is a level, to recall the

group at a proportional level. For example, you recorded the channels in group 1 at full.

When you recall [Group] [1] [At] [7][5], all the channels in group 1 will be set to 75%.

If the channels were recorded into group 1 at 80%, that same syntax would set the

group 1 channels to 60% (75% of 80).

Recall groups using [Only]:

Step 1: Press [Group] [x] to select the first group. You can use [And] and [Thru] to

select multiple groups.

Step 2: Press [Only] [Group] [y] to select only the channels that are common to groups

[x] and [y].

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 317 318

Sin comentarios

Electronic Theatre Controls Emphasis Lighting Control System Manual de usuario Pagina 118