Electronic Theatre Controls Emphasis Lighting Control System Manual de usuario descargar pdf (Pagina 63)

3 System Settings 53

Default Sneak Time

The sneak function allows you to fade channel levels over a specified time period, rather

than setting the new level immediately or manually setting the level with the level wheel or

trackpad. See Sneak, page 107 for more information.

The default sneak time is five seconds. The default sneak time can be set to anything from

zero to 99:59 minutes, following the guidelines in Default Fade Time, page 52.

Change the default sneak time:

Step 1: On your Emphasis Facepanel or from the virtual facepanel in Emphasis

Visualization, press [Setup] [1] [Enter] to display the Systems Settings menu.

Step 2: Press [6] [Enter] to choose Default Sneak Time.

Step 3: Using the numeric keypad on the Facepanel or the virtual facepanel, type in the

desired default sneak time and press [Enter].

Number of Effect Step Channels

In Emphasis you can place up to 1,000 channels (the default value for this setting) in each

step within an effect (see Blind Effects, page 149). If you do not plan to use this capacity,

you can reduce the number of channels allowed in each step. Reducing this number may

improve the memory usage and speed of your system.

Change the number of effect step channels:

Step 1: On your Emphasis Facepanel or from the virtual facepanel in Emphasis

Visualization, press [Setup] [1] [Enter] to display the Systems Settings menu.

Step 2: Press [7] [Enter] to choose Number of Effect Step Channels.

Step 3: Using the numeric keypad on the Facepanel or the virtual facepanel, type in the

desired maximum number of effect step channels and press [Enter].

Blackout Key

You can disable the facepanel’s [Blackout] key. This prevents accidental blackouts of the

entire system’s output.

Disable (or enable) the Blackout key:

Step 1: On your Emphasis Facepanel or from the virtual facepanel in Emphasis

Visualization, press [Setup] [1] [Enter] to display the Systems Settings menu.

Step 2: Press [8] [Enter] to choose Blackout Key.

Step 3: Press [0] [Enter] to disable the Blackout key, or [1] [Enter] to enable the

Blackout Key.

Flexichannel

The Flexichannel display mode is described in Flexichannel, page 32. Use this setting to

enable and disable Flexichannel mode.

Disable (or enable) Flexichannel:

Step 1: On your Emphasis Facepanel or from the virtual facepanel in Emphasis

Visualization, press [Setup] [1] [Enter] to display the Systems Settings menu.

Step 2: Press [9] [Enter] to choose Flexichannel.

Step 3: Press [0] [Enter] to disable Flexichannel, or [1] [Enter] to enable Flexichannel.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 317 318

Sin comentarios

Electronic Theatre Controls Emphasis Lighting Control System Manual de usuario Pagina 63