Electronic Theatre Controls Emphasis Lighting Control System Manual de usuario descargar pdf (Pagina 155)

5 Blind Editing 145

Create a subroutine cue:

Step 1: Press [Blind]. The Blind display defaults to cues.

Step 2: Press <Cue> [x], where [x] is the cue you want to use.

Step 3: Press [Type] [4] [Enter] to set the type to Subroutine.

Step 4: Press [1] to set Step 1.

Step 5: Press the right-arrow [

t] key to move to the step contents column.

Step 6: Press [y], where [y] is a recorded cue number, to set the cue number referenced

in step 1.

Step 7: Press right-arrow [

t] key to move to the fade type column.

Step 8: Press:

• [1] to set a Crossfade fade type. This setting overrides the fade type

recorded with the referenced cue.

• [2] to set an Allfade fade type. This setting overrides the fade type recorded

with the referenced cue.

• [3] to set a Blocking fade type. This setting overrides the fade type recorded

with the referenced cue.

• Press [Clear] to set a dynamic fade type. The dynamic fade type, displayed

in purple, follows the fade type stored with the cue.

Step 9: Press right-arrow [

t] key to set the Upfade time. This can be fixed, dynamic or

manual. Type a time value or press [Clear] to set dynamic or manual fade time.

The dynamic fade time, displayed in purple, follows the fade time stored with the

cue.

Step 10: Press right-arrow [

t] key to set the Downfade time. This can be fixed, dynamic

or manual. Type a time value or press [Clear] to set dynamic or manual fade

time. The dynamic fade time, displayed in purple, follows the fade time stored

with the cue.

Step 11: Press right-arrow [

t] key to set the Follow time. This can be fixed, dynamic or

manual. Type a time value or press [Clear] to set dynamic fade time or Hold.

Hold takes the place of a “Hold for Go” command (see below).

Step 12: Press the down-arrow [

v] key to move to the next step. Repeat steps 5 through

12 for each step in the subroutine that contains cue information.

Step 13: Press [Record] [Enter] to record the subroutine.

To add a subroutine style to a step:

Step 1: Select the step you want to modify and press [S8 -Style].

Step 2: Press:

• [1] [Enter] for Loop to Step and enter the step number to loop to, and the

number of loops you want the subroutine to perform. The Loop to Step style

is typically entered in the last step of a subroutine.

• [2] [Enter] for Bounce and enter the number of bounces you want the

subroutine to perform. The Bounce style is typically entered in the last step

of a subroutine, unless a Subroutine Fade step is also in the subroutine. In

that case, the Bounce step will be the next-to-last step.

• [3] [Enter] for Jump to Cue and enter the cue number to jump to. The Jump

to Cue style is typically entered in the last step of a subroutine.

• [4] [Enter] for Hold for Go. A Hold for Go step causes the subroutine to stop

and wait for a press of the submaster bump button. Placing a Follow time of

Hold on a cue step performs the same function.

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 317 318

Comentarios a estos manuales

Sin comentarios

Electronic Theatre Controls Emphasis Lighting Control System Manual de usuario Pagina 155

Comentarios a estos manuales

Relacionado con productos y manuales para Impresión y escaneo Electronic Theatre Controls Emphasis Lighting Control System