Electronic Theatre Controls Emphasis Lighting Control System Manual de usuario descargar pdf (Pagina 196)

186 Emphasis Console v2.0.0 User Manual

Edit an existing macro in the Macro Editing display:

Step 1: Press [Setup] [6] [Enter] to display the Macro List.

Step 2: Type the macro number on the numeric keypad and press [Enter].

Note:

You can also select macros for viewing and editing using the mouse in Emphasis

Visualization. Simply click the macro number or label in the Console Screens, Console

or Monitor layout. You can also click the command to be edited.

Step 3: Press [S1 - Edit Macro] to access the Macro Editing display. If there are

commands in the macro already, the first command is highlighted in yellow.

Step 4: Press facepanel keys to insert commands before the selected (yellow)

command.

Step 5: To select a command to edit, press:

• Right-arrow [

t] to move forward through the recorded commands one by

one.

•Left-arrow [

s] to move backward through the recorded commands one by

one.

• Down-arrow [

v] to move forward through the recorded commands in ten-

command increments. If there are less than ten commands, this jumps to the

end of the list.

• Up-arrow [

u] to move backward through the recorded commands in ten-

command increments. If there are less than ten commands, this jumps to the

beginning of the list.

Step 6: Press:

• Facepanel keys, or use the Key List, to insert commands before the selected

(yellow) command.

• [S2 - Replace] to replace the selected command with a new command.

• [S3 - Delete Entry] to remove the command from the macro.

Step 7: When done, press [Enter Macro] to record your changes.

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 317 318

Sin comentarios

Electronic Theatre Controls Emphasis Lighting Control System Manual de usuario Pagina 196