
244 Emphasis Console v2.0.0 User Manual
Step 7: Click Unzip to extract the software onto the floppy disk.
Step 8: Click OK when completed.
Step 9: Close the WinZip window and the Facepanel Software window.
Step 10: Eject the floppy disk from the Emphasis Server.
Install v3.1 Console Software
When the console is turned on with the v3.1 Console Software Disk inserted in the
Facepanel disk drive, the software loads immediately.
Install v3.1 software:
Step 1: Turn the facepanel off.
Step 2: Insert the v3.1 Facepanel Console Disk into your facepanel’s diskette drive.
Step 3: Turn the facepanel back on. The console displays the boot screen and
automatically installs the software. This process takes approximately one
minute. The console displays the following messages as the installation
progresses: Loading, Erasing Flash, Writing Flash. Wait until the Stage
display appears.
Step 4: Press [Setup] to confirm that the new software has been successfully installed.
The current software version (Express/ion 3 Version 3.1) is displayed in the lower
right corner of the display.
Step 5: Remove the diskette from the disk drive and store.
Note:
When reverting to v3.1 software, some hard keys on your facepanel will change, which
may cause the key cap to be incorrect. This will be different depending on your facepanel
and when it was purchased. See below to find what key functions change when v3.1
software is installed on your specific facepanel:
Express Facepanel - the Emphasis [Fixture] hard key reverts to a [Dimmer] hard key.
Expression / Insight Facepanel - the Emphasis [Fixture] hard key reverts to a [Dimmer]
hard key. The [Spreadsheet] hard key reverts to a [Tracksheet] hard key.
To reduce user error, any changes to your hard keys should be labeled clearly when
installing v3.1 software and using your facepanel as a stand-alone console.
Comentarios a estos manuales