Electronic Theatre Controls Emphasis Lighting Control System Manual de usuario descargar pdf (Pagina 89)

3 System Settings 79

Edit a dimmer profile:

Step 1: On your Emphasis Facepanel or from the virtual facepanel in Emphasis

Visualization, press [Setup] [1][0] [Enter] to access the Profiles display.

Step 2: Press <S1-Select Profile> [x] [Enter], where [x] corresponds to the profile you

want to edit.

Note:

You can copy another profile to the desired destination and edit from that if you wish.

Select the profile you want to copy, then press [S6 - Copy to Profile] [x] [Enter], where

[x] is the destination profile’s number.

Step 3: Use the following methods to edit the profile:

• Press [S2 - Percent] [x] [At] [y] [Enter] where [x] is the percentage of fade

completion and [y] is the desired output percentage. You can also use the

up/down arrows to set the level and the left/right arrows to select

percentages.

• Press [S2 - Percent] [x] [S4 - Clear to End] to set all percentages above the

selected one to undefined output.

• Press [S5 - Fill Between] [Enter] to have Emphasis calculate output levels

for undefined completion percentages. Emphasis will calculate an even

transition between set output levels for any undefined levels within the

profile. You must have some set levels within the profile before you press

[S5] for this to have any effect.

• Press [S7 - Reset Profile] to return the profile to its default settings.

• You can label your profile (up to 16 characters). The name will appear in the

upper-left corner of the profile display and on the profile printed report. Press

[Label] or <S7 - More Softkeys> [S2 - Label], type in the label on the

alphanumeric keyboard, and press [Enter].

Step 4: Repeat step 4 until all adjustments have been made.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 317 318

Sin comentarios

Electronic Theatre Controls Emphasis Lighting Control System Manual de usuario Pagina 89