Electronic Theatre Controls Emphasis Lighting Control System Manual de usuario descargar pdf (Pagina 138)

128 Emphasis Console v2.0.0 User Manual

Special Functions

The functions listed in this section can be used for cues, submasters, groups and focus

points.

Except

If you need to record a cue, submaster, group or focus point and there are levels on stage

you don’t want to include in the record, you can use the [Except] command to remove a

channel, group, cue or submaster from the record instruction.

Record using [Except]:

Step 1: Select channels using the procedure described in Select Channels, Dimmers

and Fixtures, page 86.

Step 2: Set levels using the procedure described in Set Levels, page 89 and Moving

Light Control, page 95.

Step 3: Press [Record] <Cue> [x], where [x] is the target cue number. You can replace

<Cue> with [Sub], [Group] or [Focus Point].

Step 4: Press:

• [Except] [y], where [y] is the channel number you want to exclude.

• [Except] [Group] [y], where [y] is the group number, to exclude channels in

that group.

• [Except] [Sub] [y], where [y] is the submaster number, to exclude channels

in that submaster.

• [Except] [Cue] [y], where [y] is the cue number, to exclude channels in that

cue.

Step 5: Press [Enter].

Solo

The [S3 - Solo] command can be used in a similar way as [Except] to limit channels that

are recorded into a cue, submaster, group or focus point. When you use [Except], you

need to know and select all the channels you want to exclude from a record command. With

[S3 - Solo], you can select the channels you want to record, and exclude all unselected

channels. When used in this way, [S3 - Solo] does not force any channel levels to zero, so

your Stage output is not affected.

Note:

[S3 - Solo] causes only SELECTED channels, not captured channels to be recorded.

Make sure that all the channels you want to include are selected, not just captured.

Record using [S3 - Solo]:

Step 1: Select channels using the procedure described in Select Channels, Dimmers

and Fixtures, page 86.

Step 2: Set levels, if required, using the procedure described in Set Levels, page 89 and

Moving Light Control, page 95.

Step 3: Press [Record] <Cue> [x], where [x] is the target cue number. You can replace

<Cue> with [Sub], [Group] or [Focus Point].

Step 4: Press<S7 - More Softkeys> [S3 - Solo].

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 317 318

Sin comentarios

Electronic Theatre Controls Emphasis Lighting Control System Manual de usuario Pagina 138