Electronic Theatre Controls Emphasis Lighting Control System Especificaciones descargar pdf (Pagina 101)

Express 125/250 User Manual, v.3.1 87

Recording a cue with a wait time

Wait time is the time that elapses between when you press [Go] and

when the actual fade begins. You can record cues with a wait time of up

to 99:59 minutes.

Wait time may be entered in normal time format or in decimal format.

When entered with a decimal point, the number must be less than one

minute (0.1 to 59.9 seconds) to be accepted. When entered without a

decimal point, a 2-digit number will be treated as seconds if less than 60

and as a calculated value of minutes and seconds if between 60 and 99.

For example, if you enter 70, the time will display as 1:10. If you enter

either a 3-digit or a 4-digit number, the last two digits, up to 59, are

interpreted as seconds. For example, if you enter 9930, the time will

display as 99:30.

The console allows you to program a wait time for either the upfade or the

downfade; not both. You can see which type of wait you have in the Wait

field of the Attribute Bar. If an upwait, a small up arrow (↑) is shown next

to the time. If a downwait, a down arrow (↓)is shown instead. If you do

not enter a wait time, the console assigns the cue a wait time of zero.

Follow these steps to change the upfade and/or downfade wait time.

Keystrokes: Action:

1. Press [Stage] or [Blind]. Selects display mode

2. Press [Cue]. Prompt reads:

Select cue number

To select cue type, press TYPE

3. Press [5] Selects cue 5

4. Press [Wait] once

or...

Press [Wait] twice.

Prompt reads:

Enter upfade wait time

or...

Enter downfade wait time.

5. Press [6]. Enters a wait time of six seconds

Corner reads:

UpWait 6

or...

DnWait 6

6. Press [Enter]. Records cue 5 with wait time of six

seconds

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 379 380

Sin comentarios

Electronic Theatre Controls Emphasis Lighting Control System Especificaciones Pagina 101