Electronic Theatre Controls Emphasis Lighting Control System Especificaciones descargar pdf (Pagina 179)

Express 125/250 User Manual, v.3.1 165

Updating submasters

Update allows you to modify previously recorded cues, groups,

submasters or focus points in Stage. Update takes levels from all captured

and selected channels, and those selected may be restricted with the

Only command.

Updating an active submaster

The following procedure illustrates how to update a submaster that has

been brought up on Stage. Note that you can update all submasters at

once by entering 0 instead of a submaster number in step 4 below. No

new channels are added when updating all submasters at once.

71.

For an explanation of captured channels, see Channel modes, page 52. For an

explanation of Only, see The Only command, page 8.

Keystrokes:

Action:

1. Press [Stage].

Selects Stage display mode

2. Set submaster 6’s slider to

10.

You cannot update a channel in a submaster to a level higher

than the submaster slider’s level. For example, if you have the

slider set to 5, the highest level to which you can update the

sub is 50.

Puts submaster 6’s full look on stage

3. Modify channel levels as

desired.

Sets submaster levels or selects

additional channels and sets their

levels

4. Press [S2], Update, [Sub].

Prompt reads:

To update submaster, press bump

or select number and press ENTER

Press 0 + ENTER to select all

submasters (only those channels

already in sub)

5. To restrict channels in the

update, use Only here.

If not restricted with Only, all captured and selected channels

are included in the update.

Selects channels to update

Prompt reads:

Select channel numbers

To cancel, press CLEAR

6. Press submaster 6’s bump

button.

Updates submaster 6

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 379 380

Comentarios a estos manuales

Sin comentarios

Electronic Theatre Controls Emphasis Lighting Control System Especificaciones Pagina 179

Comentarios a estos manuales