Electronic Theatre Controls Emphasis Lighting Control System Especificaciones descargar pdf (Pagina 139)

Express 125/250 User Manual, v.3.1 125

Controlling fades manually

The console provides two ways to take manual control of cue playback;

manual override and rate override.

Manual override

Manual override allows you to use the fader sliders to take manual control

of fade levels. When you take manual control of cue playback, moving the

fader slider controls the fade.

Leave the fader sliders at 10 before pressing [Go] to play cues back as

recorded.

When you move the fader sliders below 10, the cue runs until it reaches

the slider setting. You can set the slider before you play the cue, or move

the slider after the fade starts. The fade stops when it reaches the slider’s

level, and the slider then controls the fade. For example, if you set the

sliders at 8, the cue will play until it reaches 80 percent of its recorded

levels, then give you manual control.

Set the sliders at 0 before you press [Go] to take manual control of fade

from the beginning of cue.

Hint: If you start a cue, and the performers skip ahead to the next cue,

you have two options for speeding up to the next cue. If you do not need

the current cue to reach its full intensity level settings, press [Go] to

interrupt the current cue and begin the next one. However, if you need the

current cue to reach its full level settings, push the sliders down and then

back up to

immediately. Then press [Go] to start the next cue.

Once the fade is complete, the cue is no longer controlled by the fader.

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 379 380

Sin comentarios

Electronic Theatre Controls Emphasis Lighting Control System Especificaciones Pagina 139