Electronic Theatre Controls Emphasis Lighting Control System Especificaciones Pagina 71

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 380
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 70
Express 125/250 User Manual, v.3.1 57
Setting channel levels
You assign output levels to channels using the basic format [Channel] [#]
[At] [#] where the first number is the channel and the second is the level.
For example, [Channel] [4] [At] [7][5] sets channel 4 at 75 percent. If you
enter a single digit for the level, the console multiplies it by ten and you
must follow it with [Enter]. In other words, [Channel] [4] [At] [1] [Enter]
sets channel 4 to 10 percent. To set channel 4 to 1 percent, enter
[Channel] [4] [At] [0][1].
29
Trackpad
To set channel levels with the trackpad, select the channels whose levels
you want to modify, then move your finger up or down on the trackpad to
set the desired output level.
There are two ways to select channels for trackpad adjustment. You can
specify them on the keyboard or you can select all those channels at once
whose levels are above zero. As an example of the first of these, press
[Channel] [1] [Thru] [5]. To select all non-zero channels, press [Enter].
Full
Press [Full] to set selected channel levels to 100 percent. For example,
press [Channel] [1] [Thru] [3] [Full] to set channels 1, 2 and 3 to 100
percent.
Level key
[Level] sets selected channel levels to the output level assigned to the
[Level] key. The default value for [Level] is 100 percent. (See Setting
default Level key, page 25, for instructions on changing the Level key’s
setting.) For example, if Level is set at 75 percent, press [1] [Thru] [5]
[Level] to set channels 1, 2, 3, 4, and 5 to 75 percent.
Flash
Flash sets the selected channel’s level to 100 percent if the channel is
currently at a level at or below 50 percent. If the channel’s level is above
50 percent, Flash sets it to zero. Levels set by Flash are only maintained
while the key is pressed. For example, press [Channel] [5], then press and
hold [S8], Flash, to set channel 5 to either 100 or zero.
29.
To clear channels, press [At] [Clear].
Vista de pagina 70
1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 379 380

Comentarios a estos manuales

Sin comentarios