Electronic Theatre Controls Emphasis Lighting Control System Especificaciones descargar pdf (Pagina 228)

214 Chapter 16 Effects

Effect fade times

Each effect has an overall upfade, dwell and downfade time. When you

create an effect cue, the times default to the cue fade times in your

system settings. If you have not changed the default settings, this means

an upfade of zero seconds, a dwell of hold,

and a downfade

of zero

seconds. Press [Time] to set the effect’s upfade, dwell and downfade

times.

Fade times may be programmed from 0.1 seconds to 99:59 minutes. The

number may be entered in normal time format or in decimal format. When

entered with a decimal point, the number must be less than one minute

(0.1 to 59.9 seconds) to be accepted. When entered without a decimal

point, a 2-digit number will be treated as seconds if less than 60 and as a

calculated value of minutes and seconds if between 60 and 99. For

example, if you enter 70, the time will display as 1:10. If you enter either

a 3-digit or a 4-digit number, the last two digits, up to 59, are interpreted

as seconds. For example, if you enter 9930, the time will display as 99:30.

7. Press [2] [Enter].

Sets step out time to 2 seconds and

advances to the next field

Prompt reads:

Select low level

8. Press [1][0].

A one-digit entry must be followed by [Enter] and is

interpreted as the digit times 10.

Sets low level to 10 and advances to

the next field

Prompt reads:

Select high level

9. Press [9][0].

A one-digit entry must be followed by [Enter] and is

interpreted as the digit times 10.

Sets high level to 90 and advances to

the next field

Prompt reads:

Select step number(s)

(To clear step(s), select step

number(s), then press CLEAR)

10. Press [↑] or [↓] and repeat

steps 3-9 above.

Make changes to another step

11. Press [Record] [Enter],

Records your changes to the cue

91.

Dwell time is the length of time the effect runs between the upfade of the first

step and the downfade of the last step.

Hold

assigns an infinite dwell time,

meaning the effect runs until an associated [Clear], [Go] or bump button is pressed

to start the downfade.

92.

See Setting default fade times, page 24.

1 2 ... 223 224 225 226 227 228 229 230 231 232 233 ... 379 380

Comentarios a estos manuales

Sin comentarios

Electronic Theatre Controls Emphasis Lighting Control System Especificaciones Pagina 228

Comentarios a estos manuales