Electronic Theatre Controls Emphasis Lighting Control System Especificaciones descargar pdf (Pagina 216)

100

101

202 Chapter 16 Effects

Adding groups or focus points

The procedure for creating steps by adding groups or focus points to them

in the Blind Effects display is shown below. All channels in a group or

focus point are added to the step(s) together but they may be edited

individually later.

Keystrokes: Actions:

1. Press [S1], Step, and enter

the step number. A new

step must always have the

next highest number,

beginning with step 1.

Specifies next step to be created.

Prompt reads:

Select step number(s)

(To clear step(s), select step

number(s), then press CLEAR)

2. Press [Group] [5] [Thru]

[1][0].

To add focus points rather than groups, press [Focus Point]

rather than [Group] in this step.

Selects groups 5 through 10.

Prompt reads:

Group mode - Select group(s) and

press ADD CHANNELS to add to

step(s), or press AT to edit existing

channel level(s)

3. Press [S8], Add

Channels.

Adds groups’ channels to step.

Prompt reads:

Group mode - Select group(s) and

press ADD CHANNELS to add to

step(s), or press AT to edit existing

channel level(s)

4. Press [Record] [Enter].

Records the channels to the effect

step. Prompt reads:

Select cue number

To write effect, press STEP

1 2 ... 211 212 213 214 215 216 217 218 219 220 221 ... 379 380

Comentarios a estos manuales

Sin comentarios

Electronic Theatre Controls Emphasis Lighting Control System Especificaciones Pagina 216

Comentarios a estos manuales