Electronic Theatre Controls Emphasis Lighting Control System Especificaciones descargar pdf (Pagina 32)

18 Chapter 2 Monitor displays

Flexichannel

When you enable Flexichannel,

only channels used somewhere in the

show will appear on the display screens, subject to the following rules:

• Flexichannel displays channels whose levels are set, whether

recorded somewhere in the show or not.

• Flexichannel does not display channels whose attributes are changed

unless their levels are also set.

• Flexichannel shows the channels for all fixtures patched in the show.

• Flexichannel shows all channels on link lists.

• Flexichannel shows focus point links, if applicable (see focus point

links to the right of the levels in the illustration below).

By only displaying channels used in the show, you can reduce the amount

of time you spend moving from page to page to find channels. All other

screen elements are unchanged.

Working with Flexichannel active differs from working without

Flexichannel in only one respect, selecting channels. See Selecting

channels in Flexichannel mode, page 56 for more information.

Note: In Patch mode, channels are highlighted if they appear in the

Flexichannel list; they are grayed out if they do not.

Updating Flexichannel

When channels that were used in a show are removed from the show,

they remain in channel displays until Flexichannel is updated. Press

[Setup] [1] [Enter] [S1], Purge Flexi, to update Flexichannel. This update

follows the same rules for Flexichannel that are given above.

You also update Flexichannel displays when you load another show from

diskette or when you cycle the console’s power off and on.

See Enable / disable Flexichannel, page 27, for information about enabling

Flexichannel.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 379 380

Sin comentarios

Electronic Theatre Controls Emphasis Lighting Control System Especificaciones Pagina 32