Electronic Theatre Controls Emphasis Lighting Control System Especificaciones descargar pdf (Pagina 231)

Express 125/250 User Manual, v.3.1 217

Setting a random effect rate

An effect runs at a rate set by the submaster or cue in which the effect is

recorded.

It can also run at a random rate within minimum and

maximum parameters. Set the minimum and maximum parameters with

the following procedure to control the range of randomness of the effect.

Running an effect cue

Play back effects recorded as cues on the console’s A/B or C/D faders,

just as you would any other cue. The effect will run, using the cue’s Up,

Dwell and Down times to determine how long the cue lasts. To run the

cue, press [Stage] [Cue], enter the effect cue number, and press [Go].

An effect cue with a Hold dwell time runs on the fader until you press that

fader’s [Clear] key to begin the downfade. Press [Clear] once to fade out

an effect cue in the recorded downfade time. Press the fader’s [Clear] key

twice to cancel an effect from the fader immediately.

You may use the playback sliders to manually control the cue, allowing

you to fade the effect up and down with the playback slider.

Using an effect submaster

An effect recorded to a submaster interacts with cues and other

submasters on a pile-on basis.

Bring up the effect by pressing the

submaster’s bump button or raising the slider.

An effect submaster fades proportionally between zero and the effect’s

high level. The slider acts as a master. If the effect’s low level is normally

10 percent, moving the slider to 50 percent will reduce the effect’s low

level to 5 percent.

93.

Adjusting the rate does not affect the overall Up/Dwell/Down times for the cue or

submaster. It does, however, speed up or slow down the individual steps. For

information about controlling cue or submaster rates, see pages Rate override,

page 126 and Live control of a submaster’s rate, page 167.

Keystroke: Action:

1. Press [Blind] [Cue] [2]. Selects cue 2 in the Blind display

2. Press [S7], More

Softkeys, [S8], Attribute.

Displays available attributes across the

bottom of the screen

3. Press [S7], Random Rate. Prompt reads:

Select low random rate

(0 to 2000, 100=Normal)

4. Press [5][0] [Enter]. Specifies the slowest effect rate

Prompt reads:

Select high random rate

(0 to 2000, 100=Normal)

5. Press [2][0][0][Enter].

Specifies the highest effect rate

94.

See Adding a rate to a submaster, page 160 for information on changing the rate

of a submaster.

1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 379 380

Comentarios a estos manuales

Sin comentarios

Electronic Theatre Controls Emphasis Lighting Control System Especificaciones Pagina 231

Comentarios a estos manuales